qrb2210-unoq: update partitions based on the edk2-downstream boot fir…

[ricardosalveti]

…mware

Update filenames based on the new edk2-downstream boot firmware release available at [1], and remove partitions which are not used / required anymore.

Removing should not cause any impact on current users, as they will simply not be used anymore.

[1]
https://softwarecenter.qualcomm.com/nexus/generic/product/chip/tech-package/QRB2210_bootbinaries.1.0/qrb2210_bootbinaries.1.0-test-device-public/00010/Agatti_bootbinaries.zip

[ricardosalveti]

Created as draft as it is still pending validation.

[lool]

Thanks! Should we consider tweaking partition sizes to align with other QLI platforms and have comparable budgets for newly flashed devices? The Arduino version of the file might be constrained in keeping the location of the userdata partition.

This might be a good opportunity to add the other two hardware partitions, with blank filenames for MAC addresses:
#67
(added support here #66)

[ricardosalveti]

Thanks! Should we consider tweaking partition sizes to align with other QLI platforms and have comparable budgets for newly flashed devices? The Arduino version of the file might be constrained in keeping the location of the userdata partition.

This might be a good opportunity to add the other two hardware partitions, with blank filenames for MAC addresses: #67 (added support here #66)

That will imply a significant difference in the partition table, which is not nice for users coming from an older release, but I guess we have a bit more freedom with the non-arduino partition file.

[ricardosalveti]

I would prefer separating the partition reduction and major changes from this PR, as then we can trace regressions and issues easily, since it will be a major and breaking change.

[ricardosalveti]

Validated with qualcomm-linux/meta-qcom-3rdparty#28.

[b49020]

@ricardosalveti are you also planning to update for RB1 here: https://github.com/qualcomm-linux/qcom-ptool/blob/main/platforms/qrb2210-rb1/emmc/partitions.conf?

[ricardosalveti]

@ricardosalveti are you also planning to update for RB1 here: https://github.com/qualcomm-linux/qcom-ptool/blob/main/platforms/qrb2210-rb1/emmc/partitions.conf?

Yes, checking this one today.

[b49020]

@ricardosalveti @lumag is there anything pending for this PR to be merged?

[p-badge]

Any update on this PR why this is still pending?

[lumag]

Any update on this PR why this is still pending?

Because the answer regarding km4 was received just 4 hours ago.