Skip to content

V2.6.0

Latest

Choose a tag to compare

@mews-se mews-se released this 13 Nov 15:53

There are two builds now. TPFanControl.exe is 64-bit and TPFanControl-x86.exe is 32-bit. Take the 64-bit one unless you run 32-bit Windows or need TVicPort, since TVicPort.dll only exists as a 32-bit dll. Copying the new TPFanControl.exe over an existing install moves it to 64-bit. To stay on x86, rename TPFanControl-x86.exe to TPFanControl.exe before you copy it in, so the service and the Startup shortcut keep pointing at the same file. Close the tray and stop the service first either way.

Smart mode now leaves the fan to the BIOS while no sensor gives a sane reading, instead of taking 0 °C at face value. Some ECs answer with zeros for a while after a resume, and that used to put the fan at the bottom of the curve.

The mode that was active before a lid close, a sleep or a Modern Standby period now comes back once two sane readings are in, without the long sleeps that used to stall the program. PowerSuspendMode=1 no longer ends up stuck in BIOS mode after sleeping with the lid closed.

The step from level 7 to 64 used to wait for 4000 rpm. It now also happens once the rpm stops rising, so machines where level 7 tops out lower, or that report no rpm at all, reach full speed too.

Thanks to mwietrzy, whose PR #1 from an X395 turned up the resume problems and the 4000 rpm limit.

LpcACPIEC.bin is unchanged, the signed module from PawnIO.Modules 0.2.10 (LGPL-2.1).