% Is there a local command? on topic local $command_topic do println "Received local command: " | $this_data

if $this_data = "on" then
	setvar $relay_status = 1
	% setvar $blink = 0
	gpio_out 14 $relay_status
	% gpio_out 13 not ($relay_status)
else
    if $this_data = "off" then
	setvar $relay_status = 0
	% setvar $blink = 0
	gpio_out 14 $relay_status
	% gpio_out 13 not ($relay_status)
    endif
endif
% if $this_data = "toggle" then
%	setvar $relay_status = not ($relay_status)
%	gpio_out 12 $relay_status
%	gpio_out 13 not ($relay_status)
% endif
% if $this_data = "blink" then
%	setvar $blink = 1
%	settimer 1 500
% endif

publish local $status_topic $relay_status retained
publish remote $status_topic $relay_status retained

on topic local $Voltage_topic do println "Received local command: " | $this_data

if $this_data > 54 then
	setvar $relay_status = 1
	% setvar $blink = 0
	gpio_out 14 $relay_status
	% gpio_out 13 not ($relay_status)
else
    if $this_data < 52.5 then
	setvar $relay_status = 0
	% setvar $blink = 0
	gpio_out 14 $relay_status
	% gpio_out 13 not ($relay_status)
    endif
endif

publish remote $Voltage_topic $this_data

% The local pushbutton % on gpio_interrupt 0 pullup % do % println "New state GPIO 0: " | $this_gpio % if $this_gpio = 0 then % setvar $blink = 0 % publish local $command_topic "toggle" % endif

% Blinking %on timer 1 %do % if $blink = 1 then % publish local $command_topic "toggle" % settimer 1 500 % endif