Hi,
First of all, this is a great tool Maksim. Good job 👍
I had some trouble getting it to work, which after some debugging turned out to be hardware issue. I'm using mode 3 (single wire UART).
The TOOL0/P40 signal needs to be pulled-up on the RL78 side - 1kOhm to VDD.
I'd indicate that on the hardware diagram image you included in the repo, so it's clearer.
Cheers
Hi,
First of all, this is a great tool Maksim. Good job 👍
I had some trouble getting it to work, which after some debugging turned out to be hardware issue. I'm using mode 3 (single wire UART).
The TOOL0/P40 signal needs to be pulled-up on the RL78 side - 1kOhm to VDD.
I'd indicate that on the hardware diagram image you included in the repo, so it's clearer.
Cheers