v0.7.390

[coasting-nc]

[0.7.390]

• Overhaul of Smart Hands-Off Protection implementation (Improved the gating mechanism).

  • Also set Smart Hands-Off Protection back to 0% in the default preset (will increase it back in a future release, once more testing confirms no noticeable damping is introduced during initial turn in and other driving scenarios)

• Reduced Steering Shaft Gain from 100% to 50% in the default preset, to avoid the FFB being to strong when swtiching between "In-Game FFB (400Hz)" and "Shaft Torque (100Hz)" as Steer Torque Source.

• Fixed an issue where the selected preset was permanently showing an asterisk due to wheelbase_max_nm being considered a preset setting rather then an hardware settings.

---

This discussion was created from the release v0.7.390.

[plusodinminus]

I have Smart Hands-Off Protection enabled, but it doesn't fully eliminate oscillations on the straights. I noticed that low settings around 2-5% work best. If I set it to 10%, the vibrations become even more violent. I also tried adjusting Smoothing (15ms and higher), but didn't notice any significant difference.

[strikeeagle345]

I am still experiencing the wheel spinning randomly and going full lock after leaving a race or going to the garage. This is on an up to date CS DD+.