Hello everyone
I want to print a rectangle with a thickness of 0.52 mm on a sloping substrat part with a 45° inclination. So I pre-sloped the rectangle at 45° in cura and want to slice it from the top surface of the rectangle in the normal direction (in the direction of the red arrow in the picture)
But after I set the parameters in the scripts, the result is as shown in Figure 2.
Does anybody know the reason or Is it because my idea can't be realized?，thank you
Hello everyone
I want to print a rectangle with a thickness of 0.52 mm on a sloping substrat part with a 45° inclination. So I pre-sloped the rectangle at 45° in cura and want to slice it from the top surface of the rectangle in the normal direction (in the direction of the red arrow in the picture)
But after I set the parameters in the scripts, the result is as shown in Figure 2.
Does anybody know the reason or Is it because my idea can't be realized?，thank you